3D label free bio-transfer standards
2010年よりSensofarで共焦点法、干渉法、焦点移動法の開発に携わる。2018年より研究開発エンジニアリングマネージャーを務める。光学機械システム設計と画像処理に焦点を当てている。\n光工学におけるその総合的な研究活動は、Sensofarの研究開発グループをイノベーションと高い技術レベルで常に最先端に立つ卓越した位置付けへと導いている。
3D label free bio-transfer standards, full article
Miikka Järvinen,1 Tuomas Vainikka,1 Tapani Viitala,1 Carlos Bermudez,2 Roger Artigas,2 Anton Nolvi,1 Pol Martinez,2 Niklas Sandler,3 Edward Hæggström,1 Ivan Kassamakov1,4
1 Univ. of Helsinki (Finland)
2 Sensofar-Tech, S.L. (Spain)
3 Åbo Akademi Univ. (Finland)
4 Helsinki Institute of Physics (Finland)
Proceedings Volume 10819, Optical Metrology and Inspection for Industrial Applications V; 108190D (2018)
Event: SPIE/COS Photonics Asia, 2018, Beijing, China
Abstract
Two kinds of 3D label free Bio-Transfer-Standards (BTS) have been further developed at the University of Helsinki (UH). The first one, NanoRuler, is a staircase BTS featuring eight fatty acid bilayers which allows vertical calibration in the range of 5 to 40 nm. The second one, NanoStar, is a V-shaped BTS featuring two 5 nm tall bilayers that overlap at 10° angle. This standard enables the determination of the Instrument Transfer Function (ITF). A stability test was conducted on the BTSs, during which the standards were stored in laboratory conditions, and were profiled each week. Profiling was done using a custom-built Scanning White Light Interferometer (SWLI). The stability of NanoStar was ± 0.3 nm, and of NanoRuler ± 0.5 nm to ± 2.5 nm. The BTSs maintained their specified properties for at least six months and therefore allow vertical calibration and ITF determination. In addition, changes in surface morphology of one NanoRuler subjected to water immersion are presented. This paper reports intermediate findings during an ongoing stability test that will run for 24 months.
